SINGLE LEVER POWER TAKE- -OFF - -
(OPTIONAL) (NOT AVAILABLE FOR ALL
MARKETS) Figs. 6 and 7
To operate the power take--off, proceed as follows:
--
disengage the power take--off clutch by moving
the lever (1) fig. 6 to the UP position;
--
engage the clutch slowly by moving lever (1)
fig. 7 to DOWN position so as to start the splined
output shaft turning.
In this case, operation is totally independent of the
tractor ground speed, and you can therefore:
--
stop the tractor without stopping the power
take--off;
--
stop the power take--off without stopping the
tractor (by disengaging the power take--off
clutch).
The shaft rotates clockwise, as seen from the rear of
the tractor.
To disengage the power take--off, move the clutch
control lever (1) fig. 6 to the UP position.
WARNING
When the power take--off is not in use, the clutch
control lever (1) fig. 6 should be in the disengaged
position (UP).
DANGER
Always check that the plastic guards on the drive
shaft are in perfect condition.
IMPORTANT
To prolong bearing life RAISE the PTO clutch control
lever (1), fig. 6, when the PTO will not be used.
SECTION 3 - - FIELD OPERATIONS
1
6
1
7
3--7