Table of Contents
Advertisement
SECTION 2 - - CONTROLS, INSTRUMENTS AND OPERATION
MULTI- -FUNCTION CONTROL
The multi--function stalk controls the lights, horn, turn
indicators and headlight flasher and is also used to
switch from dipped to main beam front headlights.
Direction indicators
To indicate a right turn, push the stalk (1), fig. 13,
forward to position A.
To indicate a left turn, pull the stalk (1), fig. 13, back
to position B.
Flashing front headlights
With the lights off or on, move the stalk up to position
A fig. 14 to flash the main beam headlights. When
the stalk is released, it automatically returns to its
original position.
NOTE: The stalk switch (1) fig. 14 will only operate
with ignition key in position B fig. 1, page 3--3.
Side lights
With the stalk (1) fig. 14 in position B, rotate the outer
end of the stalk so that the indicator (1) fig. 15 aligns
with symbol (2), the side lights 'on' symbol.
Dipped headlights
With the stalk (1) fig. 14 in position B, rotate the outer
end of the stalk so that the indicator (1) fig. 15 aligns
with symbol (3), the headlights 'on' symbol.
Main beam headlights
With the indicator (1) fig. 15 aligned with symbol (3),
the headlights 'on' symbol, move the stalk down to
position C, as shown in fig. 14. The main beam
warning light on the instrument panel will illuminate
with the main beam headlights.
Horn
Press the end of control (2) on the stem as shown by
the arrow in fig. 15.
NOTE: When the indicator (1) fig. 15 is aligned with
symbol (4) all the lights are off. Only the direction
indicators and the horn are still functional.
A
B
TRE0067A
A
B
C
TRE0067A
3
1
2
4
TRE0067A
1
13
1
14
15
2--9
Advertisement
Table of Contents
