Power Take--Off - New Holland TD 60D Operator's Manual

INDEPENDENT POWER TAKE- -OFF - -
Figs. 4 and 5
To operate the power take--off, proceed as follows:
-- disengage the power take--off clutch by moving
the lever (1) fig. 4 to the DOWN position;
-- move operation selector lever (1) fig. 5 rearward
to position B;
-- engage the clutch slowly by moving lever (2)
fig. 5 to the UP position so as to start the splined
output shaft turning.
In this case, operation is totally independent of the
tractor ground speed, and you can therefore:
-- stop the tractor without stopping the power
take--off;
-- stop the power take--off without stopping the
tractor (by disengaging the power take--off
clutch).
The shaft rotates clockwise, as seen from the rear of
the tractor.
To disengage the power take--off, move the clutch
control lever (1) fig. 4 to the DOWN position.
WARNING
When the power take--off is not in use, with an
implement connected, the selector lever (1) fig. 5
should be in NEUTRAL position and the clutch
control lever (1) fig. 4 should be in the disengaged
position (DOWN).
DANGER
Always check that the plastic guards on the drive
shaft are in perfect condition.
IMPORTANT
To prolong release bearing life RAISE the PTO clutch
control lever (1), fig. 4, and move the selection lever
(1) fig. 5 to the NEUTRAL position when the PTO
will not be used for long periods of time .
3--6
SECTION 3 - - FIELD OPERATIONS
POWER TAKE- -OFF OPERATION
1
2
1
B
A
4
5