Pairing The Sensor (Searching The Sensor Id) - Cateye stealth 50 cyclocomputer CC-GL50 Instruction Manual

From "Setting the tire circumference" (page 31)

Pairing the sensor (searching the sensor ID)

Changing
the settings
MODE
(press & hold)
MODE
(press
MODE
& hold)
Continue
(page 33)
To "Night-time setting" (page 34)
This setting is required when you have an ANT+ sensor.
Selecting the sensor
Select the sensor to be paired.
(Speed sensor)
SP
ISC * (Speed/cadence sensor)
CD (Cadence sensor)
MODE
HR (Heart rate sensor)
PW (Power sensor)
* When using the CATEYE speed/cadence sen-
sor (ISC-11), select [ISC] to perform paring.
Selecting the sensor number
2 sensor IDs per sensor type can be regis-
tered into the computer.
1 (1 sensor)↔ 2 (2 sensor)
MODE
* The computer recognizes two bicycles au-
tomatically by pairing the sensor installed
to the second bicycle while selecting 2
(second bicycle).
* The next step differs depending on wheth-
er automatic search or manual ID number
entry is selected. Go to the appropriate
step according to your selection.
To add or reset the ANT+ sensor, perform pairing in the following procedure.
This unit has 2 different methods for pairing.
How to search
the sensor ID
The computer completes pairing by receiving the signal sent from the
Automatic
sensor.
search
* Generally, use this method for pairing.
When the sensor ID number is known, you can perform pairing by
entering the number.
Manual ID
number entry
* Use this method for pairing, when there are two or more ANT+ sen-
sors, such as at a race site, and automatic search cannot be done.
Description
32