Troubles Related To The Ant+ Sensor - Cateye stealth 50 cyclocomputer CC-GL50 Instruction Manual

Trouble Check Items
MEM FULL flashes. Does the maximum re-
cording time or the num-
ber of trips exceed the
upper limit?
* For details, see "Record
interval and capacity
limit" (page 23)
Does the maximum time
for one trip exceed the up-
per limit?
* For details, see "Record
interval and capacity
limit" (page 23)
The backlight does not Are the start time and end
light up even at the time set to the same hour?
preset hour.
The backlight lights up Is the start time of the
night-time set correctly?
during the daytime.
Remedy
Connect the computer to your PC
to upload the trip data (page 20).
All the trip data transferred to your
PC will be deleted from the com-
puter, and new data will be able to
be recorded.
Perform the resetting operation
(page 16) to stop the current trip.
Then, you can record as another
trip.
The backlight does not light up
when the start time and end time
are set to the same hour.
For information on how to set the
start/end time, see "Changing the
computer configuration" (page 27).
For information on how to set the
start time, see "Changing the com-
puter configuration" (page 27).

Troubles related to the ANT+ sensor

Refer to the following information when the optional or commercial ANT+ sensor is used.
* Pairing with the computer is required in order to use the ANT+ sensor. For details, see
"Pairing the sensor" (page 32).
* When a commercial ANT+ sensor is used, also refer to the instruction manual supplied
with your sensor.
Trouble Check Items
The heart rate can- Did you perform pairing
with the heart rate sensor?
not be measured ( H
does not flash).
Is the electrode pad de-
tached from your body?
Is your skin dry?
Is the electrode pad overly
worn and damaged after
long use?
Is the battery for the heart
rate sensor used up?
The heart rate mea- Is the heart rate sensor
attached correctly?
surement is not con-
stant (measurement is
performd at times, or
reset to 0).
The power cannot be Did you perform pairing
with the power sensor
measured ( P does
not flash). used?
Is the condition for
mounting the power sen-
sor cleared?
Is the battery for the
power sensor used up?
Remedy
Perform pairing (page 32).
Wear the electrode pad appropri-
ately so that it is in close contact
with the body.
Moisten the electrode pad a little.
Replace with a new one.
Replace with new batteries.
Attach the heart rate sensor in the
correct position by referring to the
relevant instruction manual.
Perform pairing (page 32).
Mount the power sensor correctly
by referring to the relevant instruc-
tion manual.
Replace with new batteries.
37