Heat & Glo RED40-N-AU Owner's Manual page 71

6. Using the fl at media pieces that were sorted out in Step
1, place one layer over the pilot shield. See Figure 14.31.
7. Place the glass frame assembly back on the appliance.
Assure that there is no rock media between the glass
and the fi rebox. Rock media in this area will prevent
the glass gasket from sealing.
WARNING
Risk of Asphyxiation or Fumes.
• Place rock media according to instructions.
• Do NOT place rock media in area between glass
and fi rebox.
• Do NOT place rock media in a position that they
may fall into area between glass and fi rebox.
• Do NOT use any media other than the rock media
supplied with this fi replace.
• Do NOT use more than one 10 lb. bag of rock
media per fi replace.
Fireplace will not function properly.
Gas leak may occur.
Figure 14.32 Front Access Media Tray
8. Position the front tabs of the front access media tray
toward the glass and then place in the groove of the
glass frame. Line up the media tray so that the left and
right cut-outs fi t within the glass frame.
DO NOT REMOVE CLEAR TAPE DO NOT REMOVE CLEAR TAPE
Figure 14.33 Location of Clear Tape
RIGHT RIGHT
CUT-OUT CUT-OUT
DO NOT REMOVE DO NOT REMOVE
CLEAR TAPE CLEAR TAPE
Heat & Glo • RED40-N-AU, RED40ST-N-AU • 2294-900 Rev. G • 7/14
CAUTION! DO NOT remove clear tape located on
bottom of media tray. Appliance will overheat and shut
down.
Figure 14.34 Placing Rock Media in Front Tray
9. Place rock media in the front tray. For an "Infi nity" look,
the rock media may be placed up against the glass and
tray.
10. Replace side panels and secure in place by using clips
on the side of the appliance.
11. The "Infi nity" look of the rock media provides a per-
ception that there is no glass on the appliance, while
maintaining the sealed combustion of the appliance.
Figure 14.35 Rock Media Installed
71