Heat & Glo RED40-N-AU Owner's Manual page 70

1. Choose 7 - 10 fl at, quarter-sized, pieces of rock media
and set them aside. These will be used later to conceal
the pilot cover. Reference Figure 14.27 for choosing
fl at pieces of glass.
NO NO
Figure 14.27 Selecting Flat Rock Media for Pilot Cover
2. The included stone placement jig MUST be used any
time rock media is placed on the burner to ensure that
none end up in the burner lighting area. Verify that the
stone placement jig is correctly installed in place in the
appliance.
3. The stone placement jig must remain in place while rock
media is placed on the basepan and around the pilot
bracket.
4. Place an even layer of rock media around the base
pan as shown in Figure 14.28 and Figure 14.29. Do
not place rock media in the slot over the burner ports.
See Figures 14.27 and 14.29. Continue to place an
even amount of rock media over the entire base pan.
DO NOT install rock media in between the tracks over
the entire length of the burner. This may cause lighting
issues, undesirable burner fl ame, or delayed ignition.
5. Remove the stone placement jig by removing the screw
as noted in Figure 14.28.
WARNING
Delayed Ignition Risk
• Place rock media according to instructions.
• Do NOT place rock media in area in front of pilot
or between burner tracks.
• Do NOT place rock media in a position that they
may fall into area in front of pilot.
• Do NOT use any media other than the rock media
supplied with this fi replace.
• Do NOT exceed one layer of rock on base pan.
Fireplace will not function properly.
Delayed ignition may occur.
70
YES YES
Heat & Glo • RED40-N-AU, RED40ST-N-AU • 2294-900 Rev. G • 7/14
ACCESS PANEL
Figure 14.28 Location of Stone Placement Jig
WARNING! Risk of Fire. DO NOT place rock media di-
rectly in front of the pilot assembly or between the burner
tracks over the burner ports.
BURNER PORT SLOT MUST BE FREE OF ROCK MEDIA
Figure 14.29 Place Rock Media
Figure 4. Burner Tracks and Area in Front of Pilot Assembly.
ROCK MEDIA
PLACEMENT JIG
PILOT SHIELD
Figure 14.30 Placing Rock Media in Base Pan on Top of Mesh
ROCK MEDIA
Figure 14.31 Placing Rock Media Over Pilot Shield
BASE PAN
NO ROCK MEDIA
ON BURNER PORTS
SCREW
LOCATION
PILOT SHIELD