Heat & Glo RED40-N-AU Owner's Manual page 67

SCREW
Figure 14.9. Attaching Chain
9. Install four hood clips (included) as shown in Figure
14.10. Outside corner trim panel will be forced into
clip on front of appliance. Put any chain slack inside
the appliance and then install corner trim panels. See
Figure 14.11 and Figure 14.12.
HOOD
CLIP
CORNER TRIM
FORCED BETWEEN
SURFACES
Figure 14.10 Clip Location
Figure 14.11 Installing Corner Panel onto Clip
Heat & Glo • RED40-N-AU, RED40ST-N-AU • 2294-900 Rev. G • 7/14
Figure 14.12 Corner Panel Installed
Service Parts
22.2
22.1
22.1
Figure 14.13 Service Parts Diagram
ITEM DESCRIPTION
Refractory Kit
1 Refractory, Corner (Qty 2 req)
2 Refractory,Side (Qty 2 req)
3 Refractory, Back
RED40ST Model With Media or Media/Lights
This kit contains the components necessary to install the
porcelain on RED40ST models that have media or media/
lights installed. For installation on other models, refer to
the instructions included with the appropriate kit.
Kit Contents:
(2) Side Panels. See Figure 14.17
(4) Corner Panels. See Figure 14.18
(2) Angle tabs and (2) Sheet metal screws.
See Figure 14.19
Tools Required
Cordless Drill
1/4 inch hex head driver tip
22.3
22.2
PART NUMBER
POR40-L
2155-219
2155-223
2155-222
67