Heat & Glo RED40-N-AU Owner's Manual page 66

Figure 14.3 Corner Panels
Figure 14.4 Angle Tabs with Screws
Installation
1. Verify the correct base pan is in the appliance before
proceeding with the porcelain installation. The base pan
required for this application has the letter "M" stamped
in it. See Figure 14.5. If the base pan does not have
the letter "M" stamped in it, contact your dealer.
M
Figure 14.5 Base Pan
2. Install back panel by placing bottom in fi rst and then tilt-
ing the top backward carefully until it touches the back
wall. Secure with angle tabs and screws in the three
pilot holes that are located on the top of the fi rebox.
Figure 14.6 Installing Angle Tab to Secure Back Panel
66 Heat & Glo • RED40-N-AU, RED40ST-N-AU • 2294-900 Rev. G • 7/14
3. Install side panels. Place bottom in fi rst and tilt top
backward carefully until it touches the side wall. Secure
with angle tabs and screws in the pilot holes that are
located on the top of the fi rebox.
Figure 14.7 Installing Angle Tab to Secure Side Panel
4. Install glass rocks in base of fi rebox according to glass
media installation instructions.
5. Install glass frame assembly according to instructions
in installation manual.
6. Install access panel assembly.
7. Attach one end of chain to the tab on the back side of
both corner panels. See Figure 14.8.
Figure 14.8 Attaching Chain
8. Remove screw from inside wall behind face of fi replace
in front of glass and to the side. Attach chain to fi re-
place using this screw. Corner panel will hang from
appliance until installed. The chain is a safety feature
and should remain connected at all times.
CAUTION! DO NOT operate appliance without safety
chains attached. Safety chains retain corner trim panels
in event of delayed ignition.