BBQ GSF2616AC Owner's Manual page 9

Step 4
a) Insert the axle (Y) into the holes on the right front leg
and back leg.
b) Put one collar (JJ) on each end of the axle, and then
put one wheel (X) on each end of the axle. Screw
one lock nut (II) on each end of the axle using the
wrench (LL) provided.
c) Insert one wheel cap (W) on each wheel.
GSF2616AC
Owner's Manual
Step 3
a) Loosen the two pre-installed bolts on the left back leg and the
left front leg, and allow 1/4 bolt's length to extend from the
legs. Align the holes on the upper side beam (S) with the
extended two bolts on the legs. Push down on the upper side
beam until it clocks into place, insert one bolt (AA), one spring
washer (CC) and one flat washer (DD) into each hole on the
legs. Tighten by hand until secure.
b) Repeat the procedure for the right upper side beam assembly
(U).
c) Loosen the lower two pre-installed bolts on the left front leg
and back leg, and allow 1/4 bolt's length to extend from the
legs. Align the holes on the side panel (T) with the extended
two bolts on the legs. Push down on the side panel until it
locks into place. Tighten by hand until secure. Repeat the
procedure for the right side panel assembly (V).
d) Go back and tighten all the bolts using the screwdriver
provided.
Step 5
a) Hook one end of the tank clip (Z) with the cart right
side panel beam, Insert one bolt (AA), one spring
washer (CC) and one flat washer (DD) into the hole
on the other end of the tank clip (Z) and the hole on
the left side panel beam. Tighten by hand until
secure.
b) Hook one end of the tank clip (AC) with the cart left
upper panel beam, Insert one bolt (AA), one spring
washer (CC) and one flat washer (DD) into the hole
on the other end of the tank clip (AC) and the hole on
the left side panel beam. Tighten by hand until
secure.
c) Insert one bolt (AA), one spring washer (CC) and one
flat washer (DD) into the hole on the end of the tank
clip (AB) and the hole on the right back leg. Repeat
the procedure on the left back leg. Tighten by hand
until secure.
d) Go back and tighten the bolt using the screwdriver
provided.
8