Table of Contents
Advertisement
Quick Links
WARNING:
Improper installation,
adjustment, alteration, service
or maintenance can cause
injury or property damage.
Read the installation,
operation and maintenance
instructions thoroughly
before installing or servicing
this equipment.
DANGER:
Failure to follow these
instructions could result in
fire or explosion that could
cause property damage,
personal injury or death.
DANGER:
DO NOT use gas grill for
indoor cooking or heating.
TOXIC fumes can accumulate
and cause asphyxiation. DO
NOT use in or on boats or
recreational vehicles.
PROP 65 WARNING:
Chemicals known to the state
of California to cause cancer,
birth defects or other
reproductive harm are created
by the combustion of
propane.
WARNING:
FOR YOUR SAFETY:
For Outdoor Use Only
(outside any enclosure)
GSF2818KM
Owner's Manual
Outdoor LP Gas Barbecue Grill
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
IF YOU ARE ASSEMBLING THIS UNIT FOR SOMEONE ELSE,
GIVE THIS MANUAL TO HIM OR HER TO SAVE FOR FUTURE
REFERENCE.
FOR CUSTOMER SERVICE, EMAIL TO
SERVICE@BBQTEK.COM OR
CALL 1-877-885-8225 (TOLL-FREE), 07:00 A.M. – 16:00 P.M.
(EST), MONDAY-FRIDAY.
Service Center: 1-877-885-8225
0
MODEL# GSF2818KM
Advertisement
Table of Contents
Related Manuals for BBQ GSF2818KM
Summary of Contents for BBQ GSF2818KM
- Page 1 MODEL# GSF2818KM Outdoor LP Gas Barbecue Grill WARNING: Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Read the installation, operation and maintenance instructions thoroughly before installing or servicing this equipment. DANGER: Failure to follow these...
-
Page 2: Grill Operation
NOTE: This grill must be used with propane gas only (propane gas cylinder not included). Installer: Leave this manual with the consumer. Consumer: Retain this manual for future reference. GSF2818KM Owner’s Manual... -
Page 3: Table Of Contents
Fuel Gas Code, ANSI Z223.1/ NFPA54. Reference to Natural Gas and Propane Installation code CSA B149.1 or Propane Storage and Handling code B149.2 IMPORTANT NOTICE: READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY AND USE. Safety First! Read and understand all warnings and precautions prior to operating your grill. GSF2818KM Owner’s Manual... - Page 4 Never allow the grill to operate while unattended to prevent uncontrolled grease fires from erupting. Never attempt to move this grill while it is in operation or while it is still hot to prevent possible personal injury. GSF2818KM Owner’s Manual...
-
Page 5: General Information
Step 3. Ensure that the valve nozzle is pointing straight and completely inserted into the venturi tube. General Information A propane gas cylinder is required for operation. This gas grill is NOT intended for commercial use. 3. Don't obstruct the ventilation opening of the cylinder enclosure. GSF2818KM Owner’s Manual... -
Page 6: Package Contents
Package Contents 2pcs GSF2818KM Owner’s Manual... -
Page 7: Hardware Contents
Hardware listed above is not scaled to exact size. (A screwdriver is required on assembly and is included for your convenience). GSF2818KM Owner’s Manual... -
Page 8: Assembly Instructions
Tighten bolts by hand until secure. Repeat the procedure for the cart right side panel and cart back panel assembly. Repeat the procedure for the left side cart panel (K) assembly. Go back and tighten all bolts using the screwdriver provided. GSF2818KM Owner’s Manual... - Page 9 (AAA) and allowed 1/4 bolt’s length to extend from tank support. Hang the two pre-installed bolts on the hole of right side panel (X) and push them down to place. d) Go back and tighten all the bolts using screwdriver provided. GSF2818KM Owner’s Manual...
- Page 10 (BB) into each pre-drilled hole. Tighten bolts by hand until secured. d) Go back and tighten all bolts using the screwdriver provided. e) Repeat the procedure for the assembly of right side shelf (V) and another one side bar tool hanger. GSF2818KM Owner’s Manual...
- Page 11 (B), then close the side burner lids. d) Connect the side burner ignition wire by sliding it onto the electrode on the right side burner assembly (U). (See the right diagram). e) Go back and tighten all bolts using the screwdriver provided. GSF2818KM Owner’s Manual...
- Page 12 (BBB). Connect the tank with regulator by screwing the regulator collar onto the tank valve. (See diagram to left) d) Conduct the leak test on page 14 to make certain all connections are connected securely. GSF2818KM Owner’s Manual...
- Page 13 Move the roller and put it into the slot on right side wall of the firebox. Tighten the screw on roller by hand. Note: Make certain the shaft will be not pulling out from the motor during operation. Fully Assembled View Right Side Left Side GSF2818KM Owner’s Manual...
-
Page 14: Operating Your Grill
9. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Install only the type of dust cap on cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of propane. GSF2818KM Owner’s Manual... -
Page 15: Checking For Leaks
3. Press the valve knob and rotate it counterclockwise to the ‘’HIGH’’ position. The burner should light immediately. If more than one burner is desired, repeat the procedure 2-3 until all desired burners are lit. 4. Adjust valve knob(s) to the desired cooking temperature. GSF2818KM Owner’s Manual... - Page 16 2. Keep the center line of GSF2818KM 3. Tighten the screw and make certain it is venturi tube and nozzle Owner’s Manual secured.
-
Page 17: Excess Flow Safety Valve Reset Procedure
When all front burners are lit, close the grill lid. Wait for 10-15 minutes; the temperature should reach 400 – 450°F. WARNING: The cylinder valve always has to be above the horizontal position, for the cylinder to have vapor withdrawl only. GSF2818KM Owner’s Manual... -
Page 18: Care And Maintenance
Inspect burner for damage (cracks or holes). If damage is found, replace with a new burner. Reinstall burner. Make certain the gas valve orifices are correctly positioned, pointing straight into burner inlet (venturi tube). Also, check position of spark electrode. GSF2818KM Owner’s Manual... -
Page 19: Troubleshooting
Turn front of grill to face wind or Flame blow out. Increase flame height. Low on propane gas. Replace or refill propane tank. Excess flow valve tripped. Refer to the Excessive flow safety valve reset procedure on page 16. GSF2818KM Owner’s Manual... -
Page 20: Waranty Program
If you have any questions related to the product or warranty, please visit our website at www.bbqtek.com or email us to service@bbqtek.com or call our customer service center at 1-877-885-8225, 07:00 A.M. to 16:00 P.M. (EST), Monday through Friday.