Programming A Rolling Code System (For U.s.a. Owners) - Lexus GS450h Owner's Manual

Hide thumbs Also See for GS450h:

Table of Contents

Test the HomeLink

by pressing the newly pro-

grammed button.

If a HomeLink

programmed for a garage door,

check to see if the garage door

opens and closes. If the garage

door does not operate, see if your

garage transmitter is of the rolling

code type. Press and hold the pro-

grammed HomeLink

remote control transmitter is of the

rolling code type if the HomeLink

indicator light flashes rapidly for

2 seconds and then remains lit. If

your transmitter is the rolling code

type, proceed to the heading "Pro-

gramming a rolling code system".

Repeat the steps above to program another device for any of the

remaining HomeLink

Programming a rolling code system (for U.S.A. owners)

If your device is rolling code equipped, follow the steps under the head-

ing "Programming HomeLink

listed below.

Locate the training button on the ceiling mounted garage door

opener motor. The exact location and color of the button may vary

by brand of garage door opener motor.

Refer to the operation manual supplied with the garage door opener for the

location of the training button.

Press the training button.

Following this step, you have 30 seconds in which to initiate step

GS450h_OM_OM30E26U_(U)

button has been

" before proceeding with the steps

5-5. Other interior features