Toshiba e-STUDIO 600 User Manual page 165

- Auto — Select this to automatically receive incoming originals when the bell rings.
Select this when the line is being used exclusively by the fax transmission.
- Manual — Select this to manually receive incoming originals after pressing the Start but-
ton on the Control Panel.
7) Dial Type
Select the dial type for the Line 1.
DP — Select this to use the Dial Pulse type for the Line 1.
MF — Select this to user the Multi-frequency type for the Line 1.
8) Dial Type (Line 2)
Select the dial type for the Line 2, if installed.
DP — Select this to use the Dial Pulse type for the Line 2.
MF — Select this to use Multi-frequency type for the Line 2.
9) Line-2 Mode
Select how the Line 2 is used, if installed.
- Tx/Rx — Select this to use Line 2 for sending and receiving a fax.
- Rx Only (24 Hour) — Select this to use Line 2 only for receiving a fax.
- Rx Only (Timer) — Select this to use Line 2 only for receiving a fax during specified
time. When this is selected, enter the start time and end time that Line 2 is used for only
receiving a fax.
10) Resolution
Select the default resolution for sending faxes.
- Standard — Select this to set the Standard mode as the default resolution appropriate
for the originals in which the text is regular size.
- Fine — Select this to set the Fine mode as the default resolution appropriate for the orig-
inals in which the text is small or a detailed drawing is contained.
- Ultra Fine — Select this to set the Ultra-Fine mode as the default resolution appropriate
for the originals in which the text is particularly small or a precision drawing is contained.
11) Original Mode
Select the default image quality mode for sending faxes.
- Text — Select this to set the Text mode as the default image quality mode appropriate for
sending text originals.
- Text/Photo — Select this to set the Text/Photo mode as the default image quality mode
appropriate for sending originals containing both text and photos.
- Photo — Select this to set the Photo mode as the default image quality mode appropri-
ate for sending photo originals.
12) Exposure
Select the default exposure for sending faxes.
Select "Auto" to automatically apply the ideal contrast according to the original or select the
contrast manually in 11 stages.
13) TTI
Select whether printing a transmission header (TTI) to identify the sender of received faxes.
14) RTI
Select whether printing a reception header (RTI) on received faxes to clearly identify the
time, date, and page count of received faxes.
15) ECM
Select whether enabling or disabling the ECM (Error Correction Mode) to automatically re-
send any portion of the document affected by phone line noise or distortion.
16) Discard
Select whether discarding the lower portion of the received fax image if it is larger than the
recording paper.
Setting up from TopAccess 165