Kyocera Mita KM-P4845w Operation Manual page 40

CHAPTER 5 MANAGEMENT AND SETTING
G Configuring of each item
1. Paper width
1
Press the N or M key to select the desired paper source.
*When the optional roll unit is not installed, "Drawer 1" ["1st
paper"] may not be selected.
Inch specifications
Metric specifications
2
Press the Enter key.
3 The selected item will flash. To enable automatic detection,
press the N or M key to select "Auto size"and proceed to
step 6.
To enter the paper width, select "Input size"and proceed to
the next step.
Inch specifications
Metric specifications
4
Press the Enter key.
Enter a paper width between 17" and 36" (210 mm –
5
920 mm).
The paper width is entered one digit at a time. Use the O or
P key to select a digit and then use the N or M key to enter
the desired value.
Inch specifications
Metric specifications
6 Press the Enter key. The display will show "set ( value ) *" and
return to the step 1 screen.
7
Press the N or M key to select "End" ["back"].
8 Press the Enter key. The printer will return to the machine
settings screen.
5-6
2. Media Type [Pre-set Temp.]
1 The selected item will flash. To enable registration of media
types for each paper source, press the N or M key to select
"ON".
Inch specifications
Metric specifications
Press the Enter key. The display will show "set ( value ) *" and
2
return to machine settings screen.
3. Paper type [Paper material]
NOTE
When "2. Media Type [Pre-set Temp.]" is set to "OFF", this item
cannot be set.
1
Press the N or M key to select a paper source.
*When the optional roll unit is not installed, "Drawer 1" ["1st
paper"] may not be selected.
Inch specifications
Metric specifications
2 Press the Enter key.
3 The selected item will flash. Press the N or M key to select
a media type.
Inch specifications
Metric specifications