Kyocera Mita KM-P4845w Operation Manual page 37

Setting
10. Standard size Select either "Architecture" or "Engineering" ["A sizes" or "B
sizes"] for the paper size. This will change the media widths
that are automatically detected by the printer.
11. Auto roll over If paper of the same size is set in multiple paper sources,
when paper in a paper source runs out during printing,
another paper source will be automatically selected and
printing will continue. If "2. Media Type [Pre-set Temp.]" is
set to "ON", however, auto roll over will not function between
different media types of the same size.
12. Buzzer When the printer runs out of paper or experiences a paper
jam during printing, this status can be conveyed by a buzzer
in addition to the messages displayed on the operation
panel. This feature is particularly convenient when the
printer is not located in the immediate vicinity of the operator.
The buzzer sounds at the following conditions:
• When the printer runs out of paper during printing;
• When the data page size and/or media type differ from
those of the selected paper tray;
• When there is a paper jam;
• When the printer runs out of toner;
• When the waste toner tank is full;
• When the "Call service" message is displayed;
• When another printer error has activated the Attention
indicator on the operation panel.
13. Mgr. code The password setting for manager can be changed.
change * Using the MNOP cursor keys, select a 4-symbol
combination of the up/down/left/right arrows to set the pin
code.
* When changing the pin code, it is recommended that you
make a note of the new code.
Description
CHAPTER 5 MANAGEMENT AND SETTING
Selectable values
Architecture/ Architecture
Engineering [A sizes]
[A sizes/B sizes]
ON/OFF OFF
ON/OFF ON
– – – – – qQrR
Default Page
5-9
5-10
5-10
5-10
5-3