Chapter 2 Prior To Set-Up; Names Of Parts; Main Body - Kyocera Mita KM-P4845w Operation Manual

CHAPTER 2

1. Names of Parts

4
5
7

(1) Main Body

1 Operation panel
Use to make settings in the printer.
2 Ejection cover
Open in case of a paper jam.
3 Ejection release lever
Operate this lever in case of a paper jam.
4 Printer body release lever
Operate this lever in case of a paper jam.
5 Bypass table
When printing documents and using the manual paper feed
setting, set paper onto on this table.
6 Bypass guide
7 Front cover
Open to set paper roll or in case of a paper jam.
8 Paper tray
Printed sheets will be stored here.
9 Paper tray support plate
Set in accordance with paper size.
PRIOR TO SET-UP
3 6 2
8 9
6 3 1
8
0 Main switch
Turn this switch ON ( | ) in order to use the printer. Conversely,
make sure this switch is OFF (
cables.
IMPORTANT
• Once you turn the main switch ON ( | ) wait for at least 20 seconds
or so before attempting to turn it OFF (
so may damage the printer.
• Make sure that you wait at least for 5 seconds after turned the
main switch OFF ( ) to remove the power plug from the outlet.
! Total counter
This indicates the paper output length.
@ Key counter insert slot
When a key counter (option) is installed, insert the key counter
here.
4
0
!
@
) before connecting network
) again. Failure to doing
2-1