Table of Contents
Advertisement
3.13.17 Using High Density Mode
When the high density data such as solid color or a page
including many images is continuously printed, the printing
density may lower. In such a case, you can prevent the
printing density by changing the mode setting to the High
Density Mode. However, if you perform the continuous
printing in this high density mode, the printing speed will be
reduced.
When the RAM disc of the printer is set to
effective or a hard disc is attached to the
printer, set the RAM disc or the hard disc to ON
Note
in the device setting menu of the printer driver.
Otherwise, the high density mode will become
invalid.
Standard (Initial setting)
01
Printing speed has a priority. Secure the appropri-
02
ate printing density by controlling the reduction
of the printing speed.
If the density is a little discolored in the standard
printing mode, use this mode.
Printing density has a priority. The printing den-
03
sity takes priority in printing operation so that the
printing speed becomes slower than when 02 is
selected.
1 1 1 1
Press the MENU key.
2 2 2 2
Press the
or
appears.
Others
3 3 3 3
Press the
key.
4 4 4 4
Press the
or
appears.
>Service
5 5 5 5
Press the
key.
6 6 6 6
Press the
or
Density Mode appears.
>>High Density
Mode
01
key repeatedly until Others >
>
key repeatedly until > Service >
>
key repeatedly until >> High
7 7 7 7
Press the ENTER key. A blinking ( ? ) appears
8 8 8 8
Press the
or
.
03
>>High Density
Mode ? 01
9 9 9 9
Press the ENTER key.
10
10
10
10
Pres the MENU key. The display returns to Ready.
3-68
3.13 Other Modes
key to select a number from 01 to
Advertisement
Table of Contents
