Table of Contents
Advertisement
3.9 Operating the Storage Device
8 8 8 8
Check that the message display has changed to
Waiting, then press the GO key. This writes the file to
the memory card and instructs the printer to
automatically print out a memory card write
information page as shown below.
The file is written onto the memory card given a
destination name (also referred to as a partition name)
which the printer automatically assigns one after
another as follows: DataS001 (first data), DataS002
(second data), DataS003 (third data)...
WRITE INFORMATION
Figure 3-12
Partition Type:
Partition Name:
Write Partition Length:
Others:
When the memory card write information page is
printed, the display returns to Ready.
9 9 9 9
Repeat above steps until you have transferred all data
(files) that you want to write to the memory card.
Each time you finish writing data, a memory card
write information page is printed from the printer
showing the information, but pertaining only to the
data just written. To see all data contained in the
memory card at once, print a list of data names as
explained. See
Printing a list of data names
(Partitions) on page
FS-C8026N Page Printer
Type of data written (currently only
type 2 is supported).
The destination name of data writ-
ten to the card.
The size of the written data on the
memory card.
Error information.
3-45.
Deleting data
It is possible to use the printer to delete data from a memory
card one by one.
To delete data from a memory card, proceed as follows.
Check that the memory card contains data. Otherwise, the
>Delete Data menu will not appear on the message
display.
1 1 1 1
Press the MENU key.
2 2 2 2
Press the
or
Card > appears.
Memory Card
3 3 3 3
Press the
key.
4 4 4 4
Press the
or
Data appears. The data name also appears (Report,
in this example).
>Delete Data
Report
5 5 5 5
Press the ENTER key. A blinking question mark (?)
appears before the data name.
>Delete Data
?Report
6 6 6 6
Press the
or
name.
7 7 7 7
Press the ENTER key. Processing appears and
the data is deleted from the memory card. The display
returns to Ready.
3-44
key repeatedly until Memory
>
key repeatedly until >Delete
key to display the desired data
Advertisement
Table of Contents
