7. The top and bottom bearings are now
accessible for inspection and/or replacement
if needed.
A. If bearings are OK, proceed to step 8.
B. If replacing the top bearing, remove the
top bearing retainer and top bearing.
C. If replacing the bottom bearing, remove it
from the door shaft or the lower sill
opening.
8. Reverse procedure to install door assembly
and check for proper operation as outlined
under the Door Adjustment and Door Switch
Adjustment section in Procedures and
Adjustments.
DOOR CATCH ASSEMBLY
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
1. Remove the top front cover as outlined under
Covers and Panels.
2. Remove the nuts and bolts that secure the
door catch assembly.
3. Reverse the procedure to install.
4. Adjust the roller catch as outlined under the
Door Catch Adjustment in Service Procedures
and Adjustments.
DOOR WINDOW
WARNING: DISCONNECT (UNPLUG) ELECTRICAL
POWER SUPPLY AND PLACE A TAG AT THE
DISCONNECT SWITCH INDICATING YOU ARE
WORKING ON THE CIRCUIT.
1. Remove the screws at the top and bottom of
the door.
REMOVE
SCREWS
2. Remove the door handle, then remove the
outer door panel.
3. Lift out the inner door panel window assembly.
4. Remove the door seal from the inside of the
left door only.
5. Remove the screws securing the window
tabs to the door bracket and lift the window
assembly out from the door frame.
INNER DOOR PANEL ASSEMBLY
6. Reverse procedure to install the replacement
window.
– 16 –
OVEN CAVITY
GLASS
PL-56052
GLASS
REMOVE
SCREWS
GLASS
PL-56053