Table of Contents
Advertisement
Fingerprint reader board
Description
Fingerprint reader board (includes cable)
Before removing the fingerprint reader board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
5.
Remove the battery (see
Remove the fingerprint reader board:
1.
Disconnect the cable from the system board (1).
2.
Remove the Phillips PM2.0×2.0 broadhead screw (2) that secures the assembly to the computer.
3.
Remove the bracket from atop the fingerprint reader board (3).
The fingerprint reader bracket is available in the Bracket Kit using spare part number 800582-001.
4.
Remove the fingerprint reader board and cable from the computer (4).
Reverse this procedure to install the fingerprint reader board.
Bottom cover on page
Battery on page
56).
32).
Component replacement procedures
Spare part number
790074-001
57
Hide quick links:
Advertisement
Table of Contents
