Table of Contents
Advertisement
2.
Remove the WLAN antenna from the routing channel on the system board (1).
3.
Remove the eight Phillips PM2.0×3.0 screws (2) that secure the system board to the computer.
4.
Lift the right side of the system board up at an angle (1).
CAUTION:
To avoid damaging or breaking the system board, use two hands when removing the board.
Do not lift up on the narrow end of the board.
5.
Pull the flat ribbon cable through the slit in the system board (2).
Component replacement procedures
61
Hide quick links:
Advertisement
Table of Contents
