Battery Insertion And Removal; Battery Charging Indicators - Symbol MC50 User Manual

2-24 MC50 Integrator Guide

Battery Insertion and Removal

Insert the battery into the battery well with the charging contacts on the battery aligning with the charging pins on the adapter, and
gently press down on the battery to ensure proper contact.
To remove the battery, press the battery release and lift battery out of the well.
Battery Well
Battery Release

Battery Charging Indicators

To charge a spare battery using the UBC adapter, connect the power supply to the UBC (see
The spare battery begins charging.
The UBC's charge LEDs show the status of the battery charging in the adapter.
The standard battery fully charges in approximately 2.5 hours and the extended capacity battery fully charges in approximately six
hours.
Battery
Figure 2-22. UBC Adapter
POWER
READY
(Green)
CHARGING or STANDBY or FAULT
(Solid Yellow) (Flashing Yellow) (Flashing Yellow)
Figure 2-23. UBC Adapter LEDs
UBC Adapter
POWER
READY
(Green)
CHARGING or STANDBY or FAULT
(Solid Yellow) (Flashing Yellow) (Flashing Yellow)
Figure 2-21), then insert the spare battery.
Table 2-4 shows battery charging status indications.