Radio; Adjusting Volume; Lowering Volume Quickly; Setting The Time - Alpine CDA-105 Quick Reference Manual

Adjusting Volume
Radio
Turn the
Rotary encoder
until the desired sound is
obtained.
SOURCE/<!> Rotary encoder
• The initial mode is Distance mode.
Listening to Radio
~/ESC
I
Preset buttons
(1 through 6)
~/III
0..
lENT
TUNE/A.ME
I
.-
"
_
_
_
-
..
-
_
.
...., t-.
BAND
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press
I-4-olI
or
~
to tune in the desired station.
Holding down
I-4-olI
or
~
will change the frequency
continuously.
• If DIGITAL SEEK is set to ON. the SEEK UP/DOWN functions only
stop on digital station frequencies while receiving an HD Radio
broadcast. Refer to "Digital Seek ON/OFF Setting" (page 18).
1
Press SOURCE/<!> to select TUNER mode.
2
Press BAND repeatedly until the desired radio band
is displayed.
F1 (FM1)
~
F2 (FM2)
~
AM ..
~
F1 (FM1)
3
Press TUNE/A.ME to select the tuning mode.
OX SEEK (Distance mode) ~ SEEK (Local mode) ~
OFF (Manual mode) -; OX SEEK (Distance mode)
iTunes Tagging lets you tag songs you hear on HD Radio stations with
your new CDA·105 and then preview, buy. and download them later
from your iTunes Tagged playlist the ne"t time you sync your iPod.
If the unit is connected to a Tagging compatible device, you can use the
iTunes Tagging function. For details. refer to the Owner's Manual of the
Tagging compatible device.
This unit cannot receive HD Radio signals (digital terrestrial radio). In
order to activate the digital radio functions described below. an optional
HD Radio Tuner module must be connected through the Ai·NET bus.
Connectable to Remote Control Interface Box
This unit may be controlled from the vehicle's audio controls.
An optional Alpine Remote Control Interface Box must be
used. For details, contact your Alpine dealer.
• Pressing
~/ESC
returns to the previous SETUP mode.
• If
/10
operation is performed for 60 seconds. SETUP is canceled.
• To synchronize the clock to another clock/watch or radio time
announcement. press and hold
0..
/ENT for at least 2 seconds after
setting the "hour." Minutes will reset to 00. If the display shows over
"30" minutes when you do this. the time will advance one hour.
Controllable with Remote Control
This unit can be controlled with an optional Alpine remote
control. For details, consult your Alpine dealer.
Point the optional remote control transmitter at the remote
control sensor.
Remote control sensor
c
'.il.)
Setting the Time
1
Press and hold F/SETUP for at least 2 seconds to
activate the SETUP selection mode.
2
Turn the
Rotary encoder
to select CLOCK ADJUST,
and then press o../ENT.
3
Turn the
Rotary encoder
to set hour.
4
Press o../ENT.
5
Repeat steps 3 and 4 above to set minute.
6
Press and hold F/SETUP for at least 2 seconds to
return to normal mode.
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.
Lowering Volume Quickly
7. .
E N