KVH Industries KVH TracVision Shop Manual page 4

Mounting to a Roof Rack
Flat-head
TORX Screws
Swivel Nuts
Rubber Cushions
Roof Rack Crossbar
Rubber Cushions
Retaining Block
Swivel Nuts
Flat Washers
Lock Nuts
• Position the roof rack crossbars 35
center.
• At least 1" clearance is required between the underside of the
antenna and the roof. To raise the antenna higher, use the
spacers supplied in the kitpack (see page 2.6 of the Installation
Guide for details).
• Always use the tamper-resistant TORX hardware supplied in the
kitpack. Do not use any substitutes.
Effective April 2004
Subject to change without notice
54-0239
Cover
TracVision A5 Shop Manual
Antenna
Mounting Bracket
Button-head
TORX Screws
1
/ " apart, measured center-to-
2
© 2004 KVH Industries, Inc., All rights reserved.