4-3C
1
2
3
4
6
7
5
1
– Undo the screws
and remove the right control cover.
– Remove the securing clip of the ball socket
3
socket
from the adjusting lever.
– Remove gasket of the control cover.
– Remove the 4 collar nuts
– Cover the crankcase.
– Place piston on wooden jig and remove both piston pin locking pins.
– Expel piston pin from piston without exerting undue force. Use a
suitable mandrel if necessary.
– Remove piston and piston pin needle-bearing from conrod eye.
– Remove the cylinder base gaskets.
!
T
HE PISTON PIN MUST NEVER BE FORCED OUT WITH A PUNCH
.
THE CONROD BEARING
Dismounting of clutch cover
– Remove collar screws and clutch cover including gasket.
NOTE: The water pump cover
do not need to be removed. The water pump and the centrifugal timer
remain in the clutch cover.
2
and unhook the ball
4
on cylinder base and remove cylinder.
CAUTION
. T
HIS WOULD DAMAGE
6
5
, the outer cover
and the cover lid
!
7
Comments to this Manuals
Latest comments: