Kodak Scan Station 700 series User Setup Manual page 23

22
• Multifeed Sensitivity: controls how aggressively the Scan
Station will work to determine if more than one document is
fed into the Scan Station. Multifeeds are triggered by
detecting air gaps between documents. This allows multifeed
detection to be used with job sets containing documents with
mixed thicknesses.
- Low: least aggressive setting and is less likely to detect
labels, poor quality, thick or wrinkled documents as multi-
fed documents.
- Medium: use if your job has varying document thicknesses
or labels attached to the document. Depending on the label
material, most documents with labels should not be
detected as a multifed document.
- High: the most aggressive setting. This is a good setting to
use if all documents have a thickness no greater than 20-lb.
bond paper.
NOTE: Regardless of the setting, "sticky" notes may still be
detected as multifed documents.
• Multifeed Response: select what action you want the Scan
Station to take when a multifeed is detected. With all options,
the condition will be logged in the Scan Station.
- Stop Scanning: scanning will stop, allowing you to correct
the multifeed. Verify that the paper path has been cleared
and continue scanning.
- Continue Scanning: the Scan Station will continue to
scan.
- Maximum Document Length (in.) — allows you to select the
maximum length of the documents in your job. If the Scan Station
detects a document longer than this value, it will determine that a
paper jam has occurred. The default is 14 inches. Maximum
length is 160 inches; minimum length is 2.5 inches.
- Reverse Page Order — if enabled, the Scan Station will reverse
the order of the scanned images from the order in which the
documents were scanned. This option is only applicable to
multipage documents.
- Allow Adding Pages To Scan Job — when enabled, you can
continue to add pages to a scan job. After all pages in the input
tray have been scanned, a message will be displayed asking if
you want to add more pages. If you select Yes, the additional
pages will be scanned and the message will be displayed again
until you select No or the 30-second timeout has occurred.
- Copies for Printing — allows you to select the number of copies
(1-99) to print.
A-61808 September 2014