Unable To Specify Desired Settings Or Unable To Send As Specified; Error Message - Konica Minolta Bizhub 222 User Manual

Troubleshooting
4.2 Unable to specify desired settings or unable to send
as specified
Perform these troubleshooting procedures if settings cannot be specified in
the fax driver or if the fax is not sent as specified.
Note
Some of the fax driver functions cannot be combined with other func-
tions.
Symptom
A fax driver setting cannot be
selected.
The "Conflicts" message with
"Unable to Select" or "Func-
tion Canceled" appears.
The fax is not sent as speci-
fied.
The watermark cannot be at-
tached.
4.2.1

Error message

Message
Cannot connect to the network.
Fax Driver
Probable cause
Some functions cannot be
combined.
An incorrect combination of
functions has been specified.
Incorrect settings are speci-
fied.
A combination of functions,
although possible in the fax
driver, is not possible with this
machine.
The paper size, orientation,
and other settings specified in
the application have priority
over those specified in the fax
driver.
The watermark is not correctly
set.
The watermark density is set
to a level that is too low.
Watermarks cannot be out-
puted in graphics applica-
tions.
Cause and remedy
A connection to the network could not be established.
Check if the network cable is correctly connected. In addi-
tion, check that the Network Settings parameter have been
correctly specified.
Action
Do not try to select settings
that are not available.
Check the settings and speci-
fy the functions correctly.
Check each setting in the fax
driver.
Enter the correct settings in
the application.
Check the watermark set-
tings.
Check the density settings.
No watermark can be output-
ed in this case.
4
4-3