Setting The Area Of Use - Sony PDW-700 Operation Manual

Setting the Area of Use

When using the unit for the first time
The area of use and the frame frequency are not
factory preset. Before using this unit, you need to
set these items. (You cannot use the unit without
setting these items.)
To set the area of use
POWER switch
MENU knob
1
Set the POWER switch to the ON
position.
The screen for setting the area of use appears
in the viewfinder.
FORMAT SETTING
COUNTRY : NOT SELECTED
SET FORMAT
AND TURN OFF ONCE.
2
Press the MENU knob.
z on the left of NOT SELECTED changes to
?, and you can now select the area of use.
FORMAT SETTING
COUNTRY :?NOT SELECTED
SET FORMAT
AND TURN OFF ONCE.
3
Turn the MENU knob to display the
desired area of use.
Setting Area of use
NTSC (J) AREA NTSC area (Japan)
NTSC AREA NTSC area (for areas other
than Japan)
PAL AREA
PAL area
a) The composite signal output from this unit is an
NTSC signal with no black setup. The frame
frequency is 59.9i.
b) The composite signal output from this unit is an
NTSC signal with a black setup (7.5 IRE). The
frame frequency is 59.9i.
c) The composite signal output from this unit is a
PAL signal. The frame frequency is 50i.
4
Set the POWER switch to OFF, then
once again to ON.
The unit is now ready for use.
Setting the Area of Use
a)
b)
c)
37