Connecting To An Ibm 468X/469X Host - Symbol LS 4008i Product Reference Manual

LS 4008i Product Reference Guide

Connecting to an IBM 468X/469X Host

This connection is made directly from the scanner to the host interface.
1. Connect the interface cable to the bottom of the scanner, as described in
the Interface Cable
2. Connect the other end of the interface cable to the appropriate port on the host
(typically, Port 9).
3. Scan the appropriate bar codes in this chapter to configure the scanner.
Note: The only required configuration is the port number. Most other
scanner parameters are typically controlled by the IBM system.
8-2
Figure 8-1. IBM Direct Connection
on page 1-3.
Host Port
Interface cable
Installing