Laser On Time - Symbol LS 4008i Product Reference Manual

LS 4008i Product Reference Guide

Laser On Time

This parameter sets the maximum time that decode processing continues during a scan
attempt. It is programmable in 0.1 second increments from 0.5 to 9.9 seconds. The default
Laser On Time is 3.0 seconds.
To set a Laser On Time, scan the bar code below. Next, scan two numeric bar codes
beginning on page D-1
numbers must have a leading zero. For example, to set an On Time of 0.5 seconds, scan
the bar code below, then scan the "0" and "5" bar codes. If you make an error, or wish to
change your selection, scan Cancel on page D-5.
Note: When scanning a PDF symbol, since rastering over the symbol
takes more time, the laser will stay on for up to 14 seconds while the
scanner views PDF. It does not use this time out bar code.
4-8
in Appendix D that correspond to the desired on time. Single digit
Laser On Time