Yamaha RX-Z11 Service Manual page 51

The analog switch settings for each sub-menu are as
shown in the table below.
SUB MENU
1. LFE/B: FRONT
2. CENTER MIX
3. PRESENCE MIX
4. FRONT/SURROUND GAIN
5. ZONE/TONE = MAX
6. ZONE/TONE = MIN
7. ZONE MONO
8. ZONE MONO OFF
9. ANALOG MUTE
10. FULL MUTE
11. PRESENCE MODE MUTE
LARGE: This mode is used for a speaker with high
bass reproduction performance (a large
unit). Full bandwidth signals are output.
SMALL: This mode is used for a speaker with low
bass reproduction performance (a small
unit). The signals of 90Hz or less are mixed
into the channel specified by LFE/BASS.
NONE: This mode is used for no center speaker.
The center content is reduced by 3dB and
distributed to FRONT L/R.
SWFR: LFE of 5.1ch signal or LFE/BASS lower
than 90Hz is output through SUBWOOFER
OUT.
FRONT: LFE of 5.1ch signal or LFE/BASS lower
than 90Hz is distributed to FRONT L/R.
INPUT: DVD ANALOG
SPEAKER OUT: 1kHz, SUBWOOFER OUTPUT: 50Hz
Input level: Both ch, -20 dBm
Volume: +6.5 dB
SUB MENU
1. LFE/B: FRONT
+21.0 dBm
2. CENTER MIX
+24.0 dBm
3. PRESENCE MIX
+18.0 dBm
4. FRONT/SURROUND GAIN
5. ZONE/TONE = MAX
6. ZONE/TONE = MIN
7. ZONE MONO
8. ZONE MONO OFF
9. ANALOG MUTE
10. FULL MUTE
11. PRESENCE MODE MUTE
FL/FR CENTER
LARGE LARGE
LARGE NONE
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
LARGE LARGE
FRONT CENTER SURROUND
-∞ -∞
-∞
-∞
-∞
+5.0 dBm +5.0 dBm +5.0 dBm
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
SL/SR SW
LARGE FRONT
LARGE SWFR
LARGE SWFR
LARGE SWFR
LARGE SWFR
LARGE SWFR
LARGE SWFR
LARGE SWFR
LARGE SWFR
LARGE SWFR
LARGE SWFR
SPEAKER OUT
SURROUND BACK FRONT PRESENCE
-∞ -∞ -∞
-∞ -∞ -∞
-∞ -∞ -∞
-∞ -∞ -∞
-∞ -∞
-∞ -∞ +1.0 dBm
-∞ -∞ -∞
-∞ -∞ -∞
-∞ -∞ -∞
-∞ -∞ -∞
-∞ -∞ +3.0 dBm
RX-Z11/DSP-Z11
SBL/SBR F. PRES. R. PRES.
LARGE O O
LARGE O O
LARGE NONE NONE
LARGE O O
LARGE O O
LARGE O O
LARGE O O
LARGE O O
LARGE O O
LARGE O O
LARGE O O
SUBWOOFER
OUTPUT
REAR PRESENCE
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
+1.0 dBm -∞
-∞ -∞
-∞ -∞
-∞ -∞
-∞ -∞
+3.0 dBm -∞
51