Yamaha RX-Z11 Service Manual page 34

RX-Z11/DSP-Z11
5. Start up "FlashSta.exe".
"Select Program" is displayed. (Fig. 2)
6. Select Program: "Inter flash memory", RS232C
Port: "COMx (serial port of the PC connected to
this unit)". (Fig. 2)
7. Confirm settings and click [OK]. "M16C Flash
Start" is displayed in about 5 seconds. (Fig. 2)
8. Reconnect the power cable of this unit to the AC
outlet.
9. Click [OK]. (Fig. 2)
"Set baudrate" is displayed. (Fig. 3)
10. Select "57600" for Baud rate and "40" for
Program_intervals (ms). (Fig.3)
11. Click [OK]. (Fig.3)
34
Select "Inter flash memory".
After a 5 seconds /
Select the serial port of the PC connected to the main unit.
Fig. 2
Select 57600bps or below for the baud rate.
* Reduce the baud rate if a transmission error occurs fre-
quently.
Fig. 3