Upper Steering - Toro Workman MD Service Manual

Upper Steering

RIGHT
FRONT
175 to 225 in lb
(20 to 25 N- -m)
5
7
9
1. Hex nut
2. Flat washer
3. Steering wheel
4. Flange nut (4 used)
5. Steering box assembly
6. Cap screw
Disassembly (Fig. 4)
1. Park machine on a level surface, stop engine, set
parking brake and remove key from the ignition switch.
2. Raise front hood to gain access to the steering com-
ponents.
Chassis
Antiseize
lubricant
7
6
Figure 4
7. Lock washer (6 used)
8. Steering shaft
9. Cap screw (4 used)
10. Bearing (2 used)
11. Carriage bolt (4 used)
Page 7 - - 10
18 to 22 ft- -lb
(25 to 29 N- -m)
11
8
4
Antiseize
lubricant
12. Steering column
13. Dust cover
14. Collar
15. Set screw
16. Steering wheel cover
3. Carefully remove steering wheel cover from the
steering wheel. Remove nut and flat washer securing
the steering wheel to the steering shaft. Pull steering
wheel from the shaft.
4. Remove cap screw and lock washer securing the
lower steering shaft knuckle to the steering gearbox in-
put shaft. Pull knuckle from the gearbox shaft.
1
2
16
3
13
10
12
10
15
14
Loctite #242
Workman MD/MDX