Transaxle Assembly - Toro Workman MD Service Manual

Transaxle Assembly

1. Assemble input shaft assembly.
1. Governor plate
2. Governor base
IMPORTANT: To prevent the screws that secure the
governor plate to the governor from loosening, ap-
ply Loctite #242 (or equivalent) to the screw threads.
IMPORTANT: Make sure to press ball bearing at the
inner race to prevent damaging the ball bearing.
Workman MD/MDX
1
2
Figure 51
2
Figure 52
1. Ball bearing 2. Input shaft
Page 5 - - 35
4
12 to 16 in- -lb
3
(1.4 to 1.8 N- -m)
3. Screw
4. Governor sleeve
A. On Workman MD, secure governor plate unit to
the governor base with two (2) screws and lock pin.
Torque fasteners from 12 to 16 in- -lb (1.4 to 1.8
N- -m).
1
B. Press ball bearing onto the input shaft.
Drive Train