Hour Meter; Headlight Switch - Toro Workman MD Service Manual

Hour Meter

Testing
IMPORTANT: Make sure to observe polarity on the
hour meter terminals when testing. Damage to the
meter may result from an improper connection.
1. Unplug wire harness connector from hour meter.
2. Connect positive (+) terminal of a 12 VDC source to
the positive terminal of the hour meter.
3. Connect negative (--) terminal of the voltage source
to the other terminal of the hour meter.
4. The hour meter should move 1/10 of an hour in six
(6) minutes.
5. Disconnect voltage source from the hour meter. Re-
connect wire harness connector to hour meter.

Headlight Switch

The headlight switch is located on the control panel (Fig.
7). This rocker switch allows the headlights to be turned
on and off.
Testing
The switch terminals are marked as shown in Figure 7.
The circuitry of the headlight switch is shown in the chart
below. With the use of a multimeter (ohms setting), the
switch functions may be tested to determine whether
continuity exists between the various terminals for each
position. Verify continuity between switch terminals.
SWITCH NORMAL
POSITION CIRCUITS
ON
OFF
Workman MD/MDX
OTHER
CIRCUITS
2 + 3 5 + 6
1 + 2 4 + 5
Page 6 - - 9
QUARTZ
0 0 0 0 0
HOURS
1/10 WHEEL: WHITE W/BLACK NUMBERS
HOUR WHEELS: BLACK W/WHITE NUMBERS
Figure 6
1
4 5
1 2
Figure 7
1. Headlight switch
RUNNING: INDICATOR
WINDOW
1
--
10
6
2
3
2. Back of switch
Electrical System