Special Tools - Toro Workman MD Service Manual

Special Tools

Order special tools from your Toro Distributor. Some
tools may also be available from a local supplier.
Multimeter
The meter can test electrical components and circuits
for current, resistance or voltage.
NOTE: Toro recommends the use of a DIGITAL Volt--
Ohm--Amp multimeter when testing electrical circuits.
The high impedance (internal resistance) of a digital me-
ter in the voltage mode will make sure that excess cur-
rent is not allowed through the meter. This excess
current can cause damage to circuits not designed to
carry it.
Skin- -Over Grease
Special non--conductive grease which forms a light pro-
tective skin which helps waterproof electrical switches
and contacts.
Toro Part Number: 505- -165
Battery Terminal Protector
Aerosol spray that should be used on battery terminals
to reduce corrosion problems. Apply terminal protector
after the battery cable has been secured to the battery
terminal.
Toro Part Number: 107- -0392
Workman MD/MDX Page 6 - - 3
Figure 1
Figure 2
Figure 3
Electrical System