Dish Network HDTV DVR Satellite Receiver User Manual page 77

Setting Auto-Tune for DVD/VCR
You can set Auto-Tune for your DVD and/or VCR. Auto-Tune allows you to return to the
channel for your DVD/VCR output when you accidentally change the channel or video
input.
1 Make sure the remote control operates your DVD/VCR.
Press and hold DVD for three seconds until all four Mode buttons are lit.
2
3 Press STAR (*).
Enter the channel used for viewing (up to three digits in range of 002 to 125), for example
4
channel "003" or "004."
5 Press POUND (#). The Mode button flashes three times to indicate programming was
successful.
Removing Auto-Tune for DVD/VCR
If you want to remove Auto-Tune for your DVD and/or VCR, follow these steps.
Press and hold DVD until it stays lit.
1
Press STAR (*).
2
Enter 00 or 000.
3
Press POUND (#).
4
Remote Control Setup
Operating Other Devices
69