Table of Contents
Advertisement
16
5.7
LK8 LIGHT INSTALLATION (OPTIONAL)
A.
Turn off the electrical and gas supply to the
appliance.
B.
Remove the frame from the unit by removing the 2
stainless steel hex head securing screws from the
bottom and lifting the frame off of the top trim bracket.
C.
Lay the frame down on its front, being careful not to
scratch the ¿ nish.
D.
Starting at the top of the frame, take one light
assembly and carefully snap it into place in the hole
provided. Repeat for each of the light assemblies.
The wires on the top 2 light assemblies will need to
be fed in behind the heat shields.
NOTE: When installing the light kit be careful not
to scratch your fi ngers on any of the exposed
screws in the frame.
E.
Connect the light assemblies to the appropriate À ags
on the wire harness. The wire harness is labeled
(TR) top right, (BR) bottom right (TL) Top left and
(BL) bottom left.
F.
Secure the wires into the clips at both sides and the
bottom of the frame. Use the extra clips provided to
retain any loose wires.
G.
Re-attach frame onto unit.
H.
Open the control panel door, leave the wires
connected to the ON/OFF switch and place the
transformer into the bottom of the unit. Plug the
transformer into the receptacle.
I.
Attach one of the wire leads from the transformer to
the lead on the wire harness labeled "TRANS", and
the other to the ON/OFF switch. Attach the last lead
on the wire harness labeled "SWI" to the ON/OFF
switch.
J.
Close the control panel door.
K.
Turn on the gas supply and electrical power.
W415-0689 / C / 06.13.12
CLIPS X 5
SWI
TRANS
Advertisement
Table of Contents
