Table of Contents
Advertisement
12
C.
Start the fasteners into each
of the six remaining mounting
holes. Align the keyholes of
the frame to the heads of the
fasteners and slide the frame
down onto the fasteners.
Ensure the frame is plumb
and level before tightening
the fasteners. NOTE: It is
recommended that the gas
and electrical be connected
to the appliance at this
stage. Both must enter the
appliance at the opening
created between the bottom
of the Torch and the bottom
of the mounting frame.
D.
Slide the front of the cabinet
over the mounting frame,
ensuring the "mesh" is to the
top. Start each of the four
screws (supplied) through the
slots. Once the cabinet has
been adjusted for depth the
four screws can be tightened.
5.2
RAIN TABS
When shipped, the rain tabs should be at a 90º
angle. Push the rain tabs down until they are at an
approximate 60º angle to assist rain in running off and
out of the unit.
W415-0689 / C / 06.13.12
3
KEYHOLE
RAIN
TAB
4
Advertisement
Table of Contents
