Troubleshooting - American Dynamics SpeedDome RASEL Series Installation And Service Manual

Troubleshooting

If a failure cannot be easily fixed, send the dome to
a repair center.
No power (no LEDs light).
Check for power coming in from J-box or controller.
Homing routine does not complete.
Green, red, and yellow LEDs are visible through
small holes in the dome housing that surround the
camera yoke. After power up, the LEDs light as
follows:
GREEN
(DS1)
PLD Loading
(approx. 20 sec)
Homing Process
Looking for Network*
Online Waiting for 1st Blink
Command**
* If the dome remains in this state, it cannot locate either the
SensorNet, RS422, or Manchester network.
** The yellow LED remains on until it receives a PTZ movement
command, then goes off. Further PTZ commands will cause
the LED to blink; otherwise, the LED is off.
No video.
1. Check the video cable and its connection to
the dome. If not OK, fix or replace the cable.
2. Check the iris setting. Open iris or set to auto
iris.
3. If the problem cannot be corrected, send the
dome to a repair center.
Video rolls when switching cameras.
Perform V-phase adjustment at the controller.
Contrast or color off.
1. Check the iris setting. Open iris or set to auto
iris.
2. If the problem cannot be corrected, send the
dome to a repair center.
SPEEDDOME OPTIMA LT INDOOR CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0181-01, REV. C)
RED YELLOW
(DS2) (DS3)
On Off Off
Off Blink On
On Off On
Blink On
Pan control absent or improper, but other
control OK.
Send the dome to a repair center.
Tilt control absent or improper, but other
control OK.
1. Check tilt belt operation. Fix the belt if
necessary.
2. If the problem cannot be corrected, send the
dome to a repair center.
Zoom, focus, and iris control is absent.
Check the flex cable connecting the camera the
housing. If you see damage, send the dome to a
repair center.
Only some camera control (for example, zoom
and focus works, iris doesn't).
Send the dome to a repair center.
9 of 14