Depending on the current zoom level, the camera will either stop at the first zoom stop setting or continue to the maximum zoom setting. For SpeedDome Optima, the first zoom stop setting is 22X (maximum optical zoom). The maximum zoom is 242X (maximum digital zoom).
Use this setting if you want a specific area to be under surveillance after an operator stops moving the dome. For SpeedDome Optima, the home position is established by programming Pattern 3 with Focus Near or Focus Far as the first command. This indicates to the dome that pattern 3 should be used as the home position.
Supported Controllers and Matrix Switching Systems SpeedDome Optima may be used with the following controllers and matrix switching systems. See notes below for specific limitations or restrictions. VM16 / ADTT16 VM32 / Feature Series AD32 Series Series SensorNet SensorNet RS-422...
End Pattern Definition Accept (save) New Pattern Go to Pattern #1 17 Call Shot Go to Pattern #2 18 Call Shot RASO AND RASI SERIES SPEEDDOME OPTIMA QUICK REFERENCE GUIDE Dome Function Go to Pattern #3 Run Pattern #1 Run Pattern #2...
Page 6
Clear Pattern #2 Clear Pattern #3 Enter V-phase Adjustment 67 Shot, followed by iris Exit V-phase Adjustment RASO AND RASI SERIES SPEEDDOME OPTIMA QUICK REFERENCE GUIDE MegaPower 48 Matrix Switcher/ Controller System See Supported AD Keyboards for button names used on specific keyboards.
Page 7
In addition, the following commands are not supported: • Set Auxiliary 4 OFF (70-F1) • Set Auxiliary 4 ON (71-F1) RASO AND RASI SERIES SPEEDDOME OPTIMA QUICK REFERENCE GUIDE Manchester Commands These commands are supported by systems using the Manchester protocol.
Other Declarations Thank you for using American Dynamics products. We support our products through an extensive and worldwide network of dealers. The dealer, through whom you originally purchased this product, is your point of contact if you have a need for service or support.
This manual is also suitable for:
Speeddome optima rasi seriesSpeeddome optima raso series