Declarations; Mechanical Specifications; Other Declarations; Regulatory Compliance - American Dynamics SpeedDome RASEL Series Installation And Service Manual

Mechanical Specifications

Camera Dome
Housing diameter................... 190mm (7.5in)
Housing height
(above ceiling)........................ 210mm (8.26in)
Bubble diameter..................... 178mm (7.0in)
Bubble depth
(below ceiling) ........................ 94mm (3.7in)
Weight.................................... 2.5kg (5.5 lbs)
Environmental Specifications
Operating temperature:
Indoor..................................... –10°C to 50°C
Humidity ................................. 0–95% non-condensing
Storage temperature .............. –20°C to 65°C

Declarations

Regulatory Compliance

REG ID................................... SV SDUW
Emissions............................... 47 CFR, Part 15
Safety..................................... UL1950
FCC COMPLIANCE: This equipment complies with Part 15
of the FCC rules for intentional radiators and Class A digital
devices when installed and used in accordance with the
instruction manual. Following these rules provides reasonable
protection against harmful interference from equipment
operated in a commercial area. This equipment should not be
installed in a residential area as it can radiate radio frequency
energy that could interfere with radio communications, a
situation the user would have to fix at their own expense.
EQUIPMENT MODIFICATION CAUTION: Equipment
changes or modifications not expressly approved by
Sensormatic Electronics Corporation, the party responsible for
FCC compliance, could void the user's authority to operate the
equipment and could create a hazardous condition.
SPEEDDOME OPTIMA LT INDOOR CAMERA DOME INSTALLATION AND SERVICE GUIDE (8200-0181-01, REV. C)
(14°F to 122°F)
(–4°F to 149°F)
EN 50130-4
ICES-003
EN 55022
CSA C22.2 No 950
EN 60 950

Other Declarations

Thank you for using American Dynamics products. We
support our products through an extensive and worldwide
network of dealers. The dealer, through whom you originally
purchased this product, is your point of contact if you have a
need for service or support. Our dealers are fully empowered
to provide the very best in customer service and support.
Dealers should contact American Dynamics at
(800) 507-6268 or (561) 912-6259 or on the web at
www.americandynamics.net.
WARRANTY DISCLAIMER: Sensormatic Electronics
Corporation makes no representation or warranty with respect
to the contents hereof and specifically disclaims any implied
warranties of merchantability or fitness for any particular
purpose.
NOTICE: The information in this manual was current when
published. The manufacturer reserves the right to revise and
improve its products. All specifications are therefore subject to
change without notice.
LIMITED RIGHTS NOTICE: For units of the Department
of Defense, all documentation and manuals were developed at
private expense and no part of it was developed using
Government Funds. The restrictions governing the use and
disclosure of technical data marked with this legend are set
forth in the definition of "limited rights" in paragraph (a) (15)
of the clause of DFARS 252.227.7013. Unpublished - rights
reserved under the Copyright Laws of the United States.
TRADEMARK NOTICE: American Dynamics and
Sensormatic are trademarks or registered trademarks of
Sensormatic Electronics Corporation. Other product names
mentioned herein may be trademarks or registered trademarks
of Sensormatic or other companies.
COPYRIGHT: Under copyright laws, the contents of this
manual may not be copied, photocopied, reproduced,
translated or reduced to any electronic medium or machine-
readable form, in whole or in part, without prior written
consent of Sensormatic Electronics.
MDR 9/03
14 of 14