Removing/Installing The Rear Wheels - Invacare Veranda 3000 series User Manual

A

5.7 Removing/Installing the Rear Wheels

WARNING!
– Only a qualified technician may change the size of the
rear wheel or the seat-to-floor height.
– If changing the size of the rear wheel or a change in
the seat-to-floor height is desired, this procedure
must be performed by a qualified technician.
– Make sure both rear wheels are the same size and
are installed into the same respective mounting hole
before using the wheelchair, otherwise injury may
occur.
– This procedure MUST be performed by a qualified
technician.
If replacing the same size rear wheel, note the mounting
position on the wheelchair frame for proper reinstallation
of the new rear wheel.
1567855-C
1. Remove the dust cap A, hex screw B, washer C, spacer (if
installed) D and locknut E that secure the rear wheel F to
the wheelchair frame G.
The spacer is used on wheelchairs with removable arms
only.
2. Repeat STEP 1 for the opposite rear wheel if desired.
3. To reinstall the rear wheel(s) onto the wheelchair, reverse
STEPS 1-2 and torque locknut to 40 ft.-lbs.
4. Adjust wheel locks. 5.14 Adjusting the Patient Operated Wheel
Locks, page 35.
A
Service
31