Empire Comfort Systems TRADITIONAL DXT30IN LP Installation Instructions And Owner's Manual page 40

14. Slide the burner to the right and lift out. See Figure 52.
NOTICE: Sliding the burner to the right ensures that the
orifice disengages from the venturi.
15. Remove the two screws securing the "air box" to the rear of
the firebox. Remove the "air box" and set aside. See Figure
53.
16. Remove the 18 screws securing the blower access panel to
the firebox and set aside. Remove the blower access panel
and set aside. See Figure 54.
Page 40
BLOWER REMOVAL/REpLACEMENT
Figure 52
Figure 53
Figure 54
17. Pull blower far enough through the blower access hole to
disconnect the wires at the connectors. See Figure 55. Once
the wires are disconnected, remove blower completely and
discard.
19. Install the replacement blower, and re-install the insert by
reversing the above steps.
Figure 55
31210-1-0713