Sony DCR-IP5 Operating Instructions Manual page 41

Playing back a tape
T
isplay function
Press DISPLAY on your camcorder or on the Remote Commander. The indicators being
displayed disappear from the screen. To display the indicators, press DISPLAY again.
DISPLAY
Using the data code function
Your camcorder automatically records not only images on the tape but also the
recording data (date/time and various settings when recorded) (Data code).
hollow the steps below to display the data code using the camcorder or the Remote
Commander.
When using the camcorder
" To display the data code
(1) In playback or playback pause mode, select FN, then press the center 0 on the
control button. The PAGE1 screen appears.
(2) Select PAGE3, then press the center 0 on the control button. The PAGE3
screen appears.
(3) Select DATA CODE, then press the center 0 on the control button. The DATA
CODE screen appears.
DATACODE
PI IT
(4) Select CAM DATA or DATE DATA, then press the center 0 on the control
button. The top of the selected button is indicated with a green bar.
(5) Select 3 OK, then press the center 0 on the control button.
(6) Select EXIT, then press the center 0 on the control button.