Recording
a picture
When recording in bright conditions, set the LCD BACKLIGHT
switch to OFF.
(I) In CAMERA,
MEMORY
(DCR-IP7BT only), playback,
or playback
pause
mode, select FN, then press the center 0 on the control button. The PAGE1
screen appears.
D
(2) Select PAGE2, then press the center 0 on the control button. The PAGE2
screen appears.
(3) Select LCD BRT, then press the center 0 on the control button. The screen used
for adjusting
the brightness
of the LCD screen appears.
(4) Select -/+,
then press the center 0 on the control button repeatedly
to adjust
the brightness.
-: todim
+: to brighten
You can also adjust the brightness by pressing q/b
repeatedly
after you select
-/+.
(5) Press DISPLAY
to clear the screen buttons.
r-
OPEN
3,4
*
LCD BRT bar
To return to the
FN
screen
Select 3 OK, then press the center 0 on the control button after step 4. The PAGE2
screen appears. Next, select EXIT, then press the center 0 on the control button.
When FN is not displayed on the screen
Press DISPLAY or 0 so that FN is displayed. You can also use DISPLAY on the Remote
Commander.
32