Remote Operation; Remote Commands; Remote Operation Security Code; Remote Answering System Operation - Radio Shack 43-3816 Owner's Manual

Ô Ô
NOTE

Remote Commands

• If you enter the correct remote
operation security code several
times, but the system does not
accept it, the system may reset
the code because of low battery
power. Enter the default security
code 000, replace the system's
backup battery, and set the
security code as desired when
you return to the system's
location.
• Before you hang up, stop and
exit remote commands until the
system beeps once. If you do
not have CPC service and hang
up while the system is playing
back messages, the system
might not recognize that you
hung up. If someone calls while
the system continues playing
messages, the caller hears a
busy signal.
Remote Answering System
Operation
• If you do not enter a digit for 10
seconds, the system hangs up.
• The system answers after 10
rings and beeps 5 times even if
it is set to Answer Off.
20
R O
EMOTE PERATION
While you are away from your home or office, you can use a
touch-tone phone, or a pulse (rotary) phone with a pocket
tone dialer, to enter your remote operation security code
and:
• set the system to answer calls
• listen to your messages
• record a new outgoing message
• delete an individual message
Remote Commands
Use the keys on a touch-tone phone or pocket tone dialer to
operate the answering system when you are away from
your home or office. Enter your selection within 10 seconds,
or the system automatically hangs up and resets to answer
the next call. Ô
Press To
1 # Play new messages
2 # Play all messages
3 # Delete current message
4 # Repeat previous message
5 # Stop and exit
6 # Skip a message
7 # Turn the system On/Off
8 # Record an outgoing message. Press 5# when you finish
9 # Record a Memo. Press 5# when you finish
0 # Monitor the room
1+1~0 Play new VIP messages (1–10)
2+1~0 Play all VIP messages (1–10)

Remote Operation Security Code

To use your system from a remote telephone, you must first
enter a 3-digit remote operation security code (see "Phone
Settings" on Page 8).
1. After the system answers and beeps once, enter the
security code.
2. Enter a remote command within 10 seconds.

Remote Answering System Operation

1. Dial your phone number.
2. After the outgoing message plays and the system
beeps, enter your remote operation security code. Ô
3. Enter a remote command.
When you finish, press
5#
to disconnect, or simply hang up.