Operation; Making And Receiving Calls Using The Handset; Selecting The Channel; Adjusting The Handset Volume - Radio Shack 43-3515 Owner's Manual

ˆ

Operation

MAKING AND RECEIVING
CALLS USING THE
HANDSET
To make a call, lift the handset and press
. Talk and the current volume setting
TALK
(see "Adjusting the Handset Volume") ap-
pear on the handset's display, and the
CHARGE/IN USE indicator on the base
lights. Then dial the number. The number
displays on the handset as you dial, then the
call's elapsed time displays.
You can also dial the number before you
press TALK . If you make a mistake, press
until the incorrect entry is
DELETE/CH
erased, then enter the correct number. To
delete the entire number, hold down
for at least 2 seconds.
CH
When you receive a call,
pears on the display. To answer it, lift the
handset from the base and press
auto talk is on, just lift the handset from the
base or press any key.
volume setting appear on the display.
To end a call, place the handset on the base
or press .
TALK

SELECTING THE CHANNEL

The phone has 20 channels. If the call
seems to disconnect for no reason during a
call, press on the handset to se-
DELETE/CH
lect a different channel.
while your phone searches for a clear chan-
nel.
DELETE/
?dYec_d]ý 9Wbb ?dYec_d]ý 9Wbb
?dYec_d]ý 9Wbb ?dYec_d]ý 9Wbb
ap-
TALK . If
JWba JWba
JWba JWba
and the current
IYWdd_d] IYWdd_d]
IYWdd_d] IYWdd_d]
appears
Operation
ADJUSTING THE HANDSET
VOLUME
To adjust the volume of the sound you hear
through the handset during a call, press
8 8 8 8 9 9 9 9
or until you obtain the desired vol-
CID
Lebkc[ Lebkc[
Lebkc[ Lebkc[
ume level.
>_]^ >_]^ >_]^ >_]^ Lebkc[ C[Z_kc Lebkc[ Lebkc[ Lebkc[ C[Z_kc C[Z_kc C[Z_kc
, , or
on the display.
Once you set the volume level, the setting is
maintained even after you hang up the
phone.
Note: When you press
VOL/CID
volume is maximum or
VOL/CID
volume is low, the setting does not change
and the phone beeps three times.
USING THE
SPEAKERPHONE
To make or answer a call using the speaker-
phone, press . The SPEAKER indi-
SPEAKER
cator lights. When you hear a dial tone, dial
the number using the base's keypad.
To set the speakerphone's volume, press
8 8 8 8 9 9 9 9
or on the base.
VOL
To end a speakerphone call, press
again.
Switching Between the Handset
and Speakerphone
To switch to the speakerphone while you are
using the handset, press
base. When you hear the conversation or
dial tone on the speakerphone, press
on the handset.
VOL/
CWn_ckc CWn_ckc Lebkc[ Lebkc[
CWn_ckc CWn_ckc Lebkc[ Lebkc[
,
Lebkc[ Lebkc[ Bem Lebkc[ Lebkc[ Bem Bem Bem
appears
8 8 8 8
while the
9 9 9 9
while the
SPEAKER
on the
SPEAKER
TALK
15