Directly On The Wall; Connecting The Handset; Using Ac Power - Radio Shack 43-3816 Owner's Manual

Ô Ô
NOTES
• Always connect the AC adapter
to the system before you
connect it to AC power. When
you finish, disconnect the
adapter from AC power before
you disconnect it from the
system.
• Use only the supplied Class 2,
Regulated 120V AC, 60Hz; 9V
DC, 500 mA, Positive (+) Tip AC
Adapter. Use of any other
power source may cause
damage.
6

Directly on the Wall

You will need a drill and screws (not supplied) with heads
that fit the keyhole slots on the bottom of the system and the
mounting bracket.
1
1. Drill two holes 3 / inches apart, one below the other.
4
2. Thread a screw into each hole, letting the heads extend
1
about / inch from the wall.
8
3. Insert the mounting bracket's tabs into the slots on the
bottom of the system. Then slide the bracket up until it
snaps into place.
4. Plug one end of the supplied modular cord into the
jack on the back of the system.
5. Plug the other end of the cord into a modular wall jack.
6. Fit the heads of the screws into the keyhole slots on the
bottom of the system and the mounting bracket, then
slide the system down until it is secure.
C
ONNECTING THE
Plug one end of the supplied coiled cord into the modular
jack on the left side of the phone, and plug the other end
into the modular jack on the handset. Then place the
handset on the cradle.
U AC P
SING OWER
Connect the supplied AC adapter to the
on the back of the phone. Then, plug the other end of the
adapter into a standard AC outlet. Ô
DC 9V Power Jack
The answering system cannot operate without AC power.
However, you can make and answer calls with the
telephone handset without AC power.
When you first connect power,
1/01
appear. The system runs a self test, sets all internal
default values, and then sounds 4 tones.
H
ANDSET
power jack
DC 9V
Initialization 12:00 AM
, , and
LINE