The Imager; Determining If The Imager Is Dirty - Kodak DCS 500 Series User Manual

CAUTION:
If you should break the glass on the anti-aliasing or IR filter while it is in the
camera, call your service representative. The broken glass can cause damage to
the imager and other parts of the camera.

The Imager

The imager is the component of the camera that records light when you capture an image.
If it should get dirty, the quality of your images can be affected.

Determining if the Imager is Dirty

Even though it is located inside the camera, it is still possible for the imager to become
dirty. There are two ways to determine whether the imager needs cleaning:
Capture a test image and look for imperfections that indicate dirt on the imager.
Access, then visually inspect the imager for dirt.
14-4
4
Carefully remove the filter
bracket from the camera.
5
Gently blow off the dust using
commercially available "canned
air." If the filter is still dirty,
please contact your dealer or
service representative.
6
To re-install: place the filter
bracket tabs into the upper two
notches on the camera lens
opening, and secure the screw at
the bottom.
7
Carefully screw the captive
screw. Do not overtighten or
cross-thread the screw.
8
Replace the lens.